HOW TO PREVENT MISINSERT OF WIRE – TO – WIRE CONNECTOR?
Mis-insertion is a kind of wrong behavior caused by carelessness in the operation process of the staff, which will not only lead to the normal operation of the equipment, but also may lead to the circuit short circuit in serious cases, so the requirements on the prevention of anti-missing insertion are very high.
Quality and application areas of pin headers
Quality is the guarantee of business development and livelihood. In all the company’s production and operation activities, insisting on quality first is a prerequisite for us to settle in the mall and obtain benefits.
Board to board connector connection problem and fault handling
How to choose the right connector The correct connection between board and board connector products can improve the service life of products. Ensure good operation of machinery and equipment.The failure and untimely treatment of board - to - board products will bring inestimable economic losses. 1. Connection of board and board connector The… Continue reading Board to board connector connection problem and fault handling
How to choose the right connector
How to choose the right connector (1) A good conductive properties Low-frequency connectors required insulation resistance and high dielectric strength, and general contact with the ground between the insulation resistance should be greater than 1Ω. In 0.44MPa's low pressure, the test voltage of 500V, do not arcing and breakdown phenomena. High-frequency connectors, in addition… Continue reading How to choose the right connector
What are FPC/FFC cables used for?
FPC/FFC cables are increasingly used to connect LCD panels to printed circuit boards or to connect two printed circuit boards in a wide range of products and equipment, such as industrial equipment, home appliances, printers, LCD TV sets, and mobile devices. This has led to increased demand for connectors applicable for these cables.
Personal opinion of wire-to-board connectors
The connector’s expert should be aware what’s the wire-to-board connector?
Why go to shows and exhibitions?
Twenty years ago, companies were using large exhibitions to present their new products. Today, the web outperforms any exhibition in timing and in data quality.
Common fault analysis and simple handling of connectors
Now it is a common phenomenon to use connectors, especially when there are some small problems. If it is not a matter of principle, it is quite convenient to learn how to deal with it by yourself, which can also improve efficiency.